Update 'readme.md'

readme.md

@@ -1,2 +1,25 @@
-#IzControl#
+IzControl
+=========
 IzControl is an application that makes is possible to easily control appliances over the network using UDP, telnet and other protocols.
+
+Example setup on Raspberry Pi
+=============================
+1. Download the [Raspberry Imager](https://www.raspberrypi.com/software/) tool and flash the SD card with the default Raspbian Image
+1. Hook the Pi to a monitor and a keyboard.
+1. Insert the SD card into the Raspberry Pi and power it up.
+1. Go trough the setup (you can skip the network and language setups), then the system will reboot. For this example, the username will be control and the password raspicontrol
+1. Open terminal to install desired software run the following
+    ```
+    sudo apt install nginx php-fpm composer git -y
+    cd /var/www && sudo rm -rf html
+    sudo git clone https://gitea.linkensphere.com/enzo/izcontrol.git html
+    cd html
+    sudo cp defaultconf /etc/nginx/sites-enabled/default
+    sudo chown -R www-data:www-data html
+    sudo nginx -s reload
+    ```
+At this point, you should see the control panel on the local of Pi (run ifconfig to see the ip addres)    
+
+Optionally you can
+- run the above in a remote shell, in order to to do this  go to the start menu > Preferences > Raspberry Pi Configuration . Now click on Interfaces and click enable next to SSH and click OK .
+- Remove the desktop environment, in Menu > Preferences > Raspberry Pi configuration > System > Boot, select **To CLI**, then reboot. The PI will use less memory. If you want to re-enable desktop, just run sudo raspi-config on the terminal and you can find it under system.